Getting Started 2
Keysight Infiniium MXR-Series Real-Time Oscilloscopes User's Guide 47
When you drag and drop a measurement icon on a waveform, the icon outline
changes color to match the color of each waveform it touches so you can easily
see which waveform will be measured.
For edge-sensitive measurements, a circled number appears in the waveform
marker color when you drop the measurement icon on a waveform. This number
shows exactly where the measurement is being made. It appears next to the
measurement readout in the Results pane. This feature helps you distinguish
measurement results from each other when you make multiple measurements on
the same waveform but at different waveform features.
Using Quick Measurements
The default [Multi Purpose] key action is QuickMeas (see "[Multi Purpose] Key" on
page 41). With this configuration:
• To turn on the quick measurement display, press [Multi Purpose]. The 10 preset
measurements defined in the Quick Measurement configuration are enabled
and results appear on the screen for the first waveform source.
• To measure parameters for another waveform, press [Multi Purpose] until that
waveform is the one shown in the measurements window in the Results pane.
Continuing to press [Multi Purpose] cycles through each of the waveforms
available.
• To turn off the quick measurement display, cycle through all channels until the
measurements are turned off.
See the Infiniium oscilloscope application's online help for information on how to
configure the quick measurement capability. See "Accessing the Online Help" on
page 51.
To Next Page
Loading...
Need help?
General
