86 Keysight Infiniium MXR-Series Real-Time Oscilloscopes User's Guide
6 Testing Performance
Time Scale Accuracy (TSA) Test
This procedure verifies the maximum TSA specification for the oscilloscope.
Description TSA refers to the absolute accuracy of an oscilloscope's time scale. Because TSA
depends directly on frequency of a crystal oscillator, it is comprised of two
components: an initial setting accuracy component and an aging component.
The initial setting accuracy component applies to the oscilloscope's 10 MHz OCXO
frequency accuracy immediately after a calibration, whether performed at the
factory, by a customer, or by a Keysight service center. The aging component
scales linearly from the time since the last time scale calibration and adds to the
initial setting accuracy component.
Specifications TSA is published as a warranted specification, expressed by the following formula.
The aging component is specified by the 10 MHz OCXO manufacturer while the
initial setting accuracy component is derived from absolute frequency
measurements of the 10 MHz OCXO in a large sample of production units after a
time scale calibration prior to shipment.
Longer is better to further reduce the uncertainty and allow the OCXO frequency
to settle onto the aging trajectory of the crystal inside the oscillator.
TSA = ±(8 ppb initial + 75 ppb/year aging)
To see the number of years since the last time scale calibration, open the
oscilloscope application and click Utilities > Calibration.... The TimeScale entry in the
Calibration dialog box shows the date of the last time scale calibration.
These measurements require the 10 MHz OCXO to be powered on for a minimum of 2 hours.
To Next Page
Loading...
Need help?
General
