Key Reference
Amplitude
104
Corrections Accesses the corrections submenu to enable the corrections
function for amplitude compensation. The amplitude
correction is used to compensate the gain/attenuation from
antenna/cable. Please refer to the procedures below to use
the amplitude correction function.
1 Please refer to the procedures below to create a
correction file in BSA PC software.
a Open the PC software.
b Press File > New > Correction to access the correction file
editing pop- up menu.
c Refer to to add the pount data with frequency and
amplitude offset value.
Figure 1 Editing correction file in PC software
d When the editing is completed, press Save/Save As to
save the correction file.
To Next Page
Loading...
