Keysight Technologies N9322C - Limit

159
Key Reference
Limit
Limit
Limits Accesses softkeys that allow you to control and define the
parameters of limit lines.
Key access: Shift > Limit
Limit 1
Limit 2
selects either of the available limits. The Limit 1 and
Limit 2 keys access softkeys to set parameters for the
selected limit.
Key access: Shift > Limit
Type
Upper lower
defines the limit to be edited as an upper
or lower limit. An upper limit will
indicate a fail if trace 1 exceeds this limit.
A lower limit will indicate a fail if trace 1
falls below the limit.
Key access: Shift > Limit > Limit 1/2
Limit
On Off
Toggles the limit line function to on or
off. The limit points must exist before the
limit function can be turned on. Either
Limit or Margin, as well as Test , must be
turned on for a limit test. Limit points
must be defined before the Limit function
can be turned on.
Key access: Shift > Limit > Limit 1/2