17
Getting Started
Power On and Check
Check for Instrument Messages
The spectrum analyzer has two categories of instrument
messages: error and warning messages. A error message is
triggered by operation errors, for example, parameter setting
conflicts or data input that is out of the range of a
parameter. An warning message may be triggered by
hardware defects which could result in damage to
instrument.
Here are some tips to check the instrument messages.
1 Check the display to see if any messages display in the
status bar. Press [System] > System Info > Error History to review
each message. Refer to Chapter 5, “Instrument Messages” for
detailed system message descriptions.
2 When you have reviewed and resolved all of the error
messages, press [System] > System Info > Error History > Clear
error queue to delete the messages.
3 Cycle the power to the analyzer and re- check to see if the
instrument messages are still there.
4 If the error messages cannot be resolved, please contact the
Keysight Customer Contact Center for assistance or service.
To Next Page
Loading...
