Functions and Measurements
Channel Scanner
66
List N Channel Scanner
The List N channel scan is used for listing the frequency
channels from specific channel standard or customized
frequency bandwidth.
Please refer to the procedures below to perform a List N
channel scanner measurement.
1 Connect the antenna to RF IN connector.
2 Turn on the channel scanner function.
Press Meas > Channel Scanner}
3 Press Meas > Scan Mode > List to set the scan mode to List
N channel mode. Input the channel number you need to
monitoring. Press Enter as a terminator.
4 Press List Edit to access the submenu to edit the scan
range.
Press Insert to insert a channel and access the channel
setting submenu to customize the channel parameters.
Press Edit Method Std. It allows you to set the range
according to the embedded communication standard, such
as CDMA and GSM which is used specifically in different
countries.
Press Signal Std to load a standard file as your need.
Please refer to
“Loading a File” on page 98 for details.
Press Chn ID to select the specific channel according to the
signal standard.
Or press Edit Method Custom. It allows you to set the
customer- defined scan as your need.
Press Freq to set the center frequency of the current
channel.
Press Bandwidth to set the bandwidth of each frequency
channel which is used to calculate the channel power.
The first channel editing is completed. Press Return > Insert
to add more channels as your need.
If there is a need to further edit the channel set previ-
ously, press Index, rotate the knob to highlight the channel
as your need for further editing.
Press Apply as a terminator to apply all the settings above.
To Next Page
Loading...
