Getting Started
Helpful Tips
26
Press {IP Address Static} to manually set the IP address,
gateway and subnet mask with the proper LAN information,
or just press {IP Address DCHP} to set the IP address in LAN
dynamically according DCHP.
Press {Apply} to enable the LAN connection according to the
IP configuration you set.
GPIB
Press [System] > {More} > {Port Setting} > {GPIB Address} to set
the GPIB address for the analyzer. This softkey is only vaild
after the option G01 is installed.
Timed Power On/Off
Pressing [System] > {Power On/Off Preset} > {Timed Pwr On} or
{Timed Pwr Off} sets the time switch to power on/off the
N9322C in a user- defined time and date. This function
requires the power supply connected.
Press {Repeat Mode Once/Everyday} to set the N9322C boot
up/off in the pre- saved time everyday. The pre- saved date is
invalid in this mode.
Power Preset Last
Press [System] > {Pwr On/Preset} > {Power On Last} to activate
this function. For the standard N9322C, this operation only
save the last state if the analyzer is turned off by the front
panel power switch.
To Next Page
Loading...
