Functions and Measurements
Channel Scanner
68
Channel Scanner Setup
To customized the channel scan process, you can press Meas
> Channel Scanner > Setup to set the measurement interval and
rule in the submenu.
The Meas Interval is a value of time/distance during which the
every two scan process is triggered. When it is set to off, the
channel will be scanned with default settings.
The Interval Type is toggled between time and distance. When
it is set to Time, the minimum interval time is 100 ms. When
it is set to Distance, it allows you to measure the channel
with the specific distance on the road test. The minimum
interval distance is 1 meter.
The Measure Rule and Search Rule is toggled between Speed
and Accuracy.
For each scan process, the analyzer will first search and find
out the available channels according to the selected scan
mode. Then, a precise measurement will perform to get the
scan result.
The accuracy mode in measurement rule is set as default to
get the precise measurement for the searching- out channels.
The speed mode will speed the measurement but reduce the
measurement accuracy. It is set to default in search rule to
search out the available channels approximately.
The To p Cy cle number is the searching times for each
measurement. It allows you to measure the specific
searching- out channels continuously.
To Next Page
Loading...
