95
Functions and Measurements
Files Operation
Files Operation
The analyzer will store and retrieve data files similar to
using a PC. The analyzer allows you to view and save files in
the internal storage of the analyzer or to a USB storage
device. This section provides information on how to locate
catalogs (file types) and to save files.
Locating and Viewing Files in the Catalog
The analyzer has four types of files:
State records the current controls and settings of the analyzer. Use
this file type for saving test parameters for future recall,
such as frequency and BW settings. (file extension: .STA).
Trace stores trace information (file extension: .TRA).
Setup records the system setting information, such as language,
date/time, and power saving mode. This file type is not used
for test parameter setup information. (file extension: .SET).
Screen stores screen captures of the display (file extension: .JPG).
Limits which stores data sets to determine whether a trace has
exceeded preset specifications (file extension: .LIM)
CSV records the trace data and available for review on PC.
(file extension: .CSV)
Task Planner contains the user- defined measurement tasks in sequence
which make the test task easier in field test.
(file extension: .TPF).
Correction The amplitude correction file is used for trace amplitude
offset compensation. Please refer to “Corrections” on page 104
to edit and save the correction file on BSA PC software.
(file extension: .COR).
Standard contains the frequency range and corresponding parameters
for a specific communication standard. It allows you to
recall those default settings for the singal searching and
testing in that range. (file extension: .STD).
To Next Page
Loading...
