Keysight N774 C Series

48 Keysight N774xC Series Multiport Power Meter Programming Guide
3 Instrument Setup and Status
Parameters: None
Response: String
Example: :syst:comm:eth:dgat? -> “192.168.101.11“
Command: :SYSTem:COMMunicate:ETHernet:DGATeway:CURRent?
Syntax: :SYSTem:COMMunicate:ETHernet:DGATeway:CURRent?
Description: Get the currently used default gateway.
Parameters: None
Response: String
Example: :syst:comm:eth:dgat:curr? -> “192.168.101.11“
Command: :SYSTem:COMMunicate:ETHernet:DHCP:ENABle?
Syntax: :SYSTem:COMMunicate:ETHernet:DHCP:ENABle?
Description: Check whether DHCP is enabled or disabled.
Parameters: None
Response: Boolean (0 | 1)
Example: :syst:comm:eth:dhcp:enab? -> 1
Command: :SYSTem:COMMunicate:ETHernet:DHCP:ENABle
Syntax: :SYSTem:COMMunicate:ETHernet:DHCP:ENABle
Description: Enable or disable DHCP
Parameters: Boolean (0 | 1 | off | on)
Response: None
Example: :syst:comm:eth:dhcp:enab on