20 Keysight N774xC Series Multiport Power Meter Programming Guide
2 Command Summary
Command Summary
The commands are ordered in a command tree. Every command belongs
to a node in this tree.
The root nodes are also called the subsystems. A subsystem contains all
commands belonging to a specific topic. In a subsystem there may be
further subnodes.
Table 4 on page 20 gives an overview of the command tree. You see the
nodes, the subnodes, and the included commands.
Table 4 Command Summary
Command Page
CONFigure Subsystem
:CONFigure:MEASurement:SETTing:ACTual? Page 60
:CONFigure:MEASurement:SETTing:NUMBer? Page 60
:CONFigure:MEASurement:SETTing:PRESet Page 60
:CONFigure:MEASurement:SETTing:CANCel Page 61
:CONFigure:MEASurement:SETTing:RECall Page 61
:CONFigure:MEASurement:SETTing:SAVE Page 61
:CONFigure:MEASurement:SETTing:ERASe Page 62
Command Page
FETCh Subsystem
:FETCh[n]:POWer? Page 63
:FETCh[n]:POWer:ALL? Page 63
:FETCh[n]:POWer:ALL:CSV? Page 64
:FETCh[n]:POWer:ALL:CONFig? Page 64
:FETCh[n]:POWer:MAX? Page 64
:FETCh[n]:POWer:MIN? Page 65
:FETCh[n]:POWer:EXTRema:RESet Page 65
To Next Page
Loading...
