Keysight N774 C Series Programming Guide

Keysight N774xC Series Multiport Power Meter Programming Guide 15
Introduction to Programming 1
Common Commands
The IEEE 488.2 standard has a list of reserved commands, called common
commands. Some of these commands must be implemented by any
instrument using the standard, others are optional.
Your instrument implements all the necessary commands, and some
optional ones. This section describes the implemented commands.
Common Command Summary
Table 3 on page -15 provides a summary of the common commands.
Table 3 Common Command Summary
Command Parameter Function Page
*CLS Clear Status Command page 28
*ESE Standard Event Status Enable Command page 28
*ESE? Standard Event Status Enable Query page 29
*ESR? Standard Event Status Register Query page 29
*IDN? Identification Query page 30
*OPC Operation Complete Command page 30
*OPC? Operation Complete Query page 31
*OPT? Options Query page 31
*RST Reset Command page 31
*STB? Read Status Byte Query page 32
*TST? Self Test Query page 31
*WAI Wait Command page 31
NOTE
These commands are described in more detail in IEEE-Common Commands on
page 28.

Keysight N774 C Series Specifications

General

Brand	Keysight
Model	N774 C Series
Category	Measuring Instruments
Language	English