60
Reversing Wheel Lock
3. Remove the wheel lock assembly from the wheel lock bar. For a low profile scissor lock, use a 5mm
Allen wrench to remove the two bolts. For the short throw and push to lock flush mount, remove
hardware using a 4mm Allen wrench and a 10mm wrench. For the push and pull to lock, loosen and
remove the top lock nuts and then grasp the assembly so the spring does not come out of the linkage
hole when sliding off the arbors.
4. Rotate the wheel lock bar 180°.
Scissor Lock
Short Thro
Scissor Lock
Push to Lock Flush Mount
Wheel Lock
Push and Pull to Lock
Wheel Locks
Push to Lock Flush Mount Wheel LockPush and Pull to Lock Wheel Locks
or
To Next Page
Loading...