61
Reversing Wheel Lock
5. Reinstall the wheel lock assembly onto the wheel lock bar. For a low profile scissor lock, use a 5mm
Allen wrench to install the two bolts. For the short throw and push to lock flush mount wheel locks,
install hardware using a 4mm Allen wrench and a 10mm wrench. For the push and pull to lock, slide
the assembly back onto the arbors. To install the spring on a push to lock, pull the curved spring arm
over the arbor shoulder. To install the spring on a pull to lock, pull the spring arm end into the wheel
lock bar hole (thin screwdriver will help with this). Place and tighten the top lock nuts to secure. See
image below.
NOTE: Always tighten wheel lock hardware by alternating between the two bolts while tightening a
little at a time. This prevents overclamping on one set of hardware which can lead to binding of the
fasteners and increased difficulty in removal.
6. Test the wheel locks. Ensure wheel lock arms embed in tires at least 1/8 inch when locked. If they do
not embed at least 1/8 inch, readjust wheel lock and test again.
Scissor Lock
Short Thro
Scissor Lock
Push to Lock Flush Mount
Wheel Lock
Push and Pull to Lock
Wheel Locks
To Next Page