55
4
4
Features of your vehicle Mirrors
4) Canadian Programming
Canadian radio-frequency laws require
transmitter remote signals to "time-out"
(or quit) after a couple seconds of trans
-
mission, which may not be long enough
for HomeLink to pick up the signal
during programming.
If you live in Canada or you are having
difficulties programming a gate operator
or garage door opener by using the pro
-
gramming procedures, replace "Pro
-
gramming a New HomeLink Button"
step 3 with the following:
While the HomeLink indicator light (7) is
flashing orange, press and release
("cycle") your device's hand-held remote
every two seconds until the HomeLink
indicator light (7) changes from orange
to green. You may now release the
hand-held remote button. Then proceed
with "Programming a New HomeLink
Button" step 4.
2. Operating HomeLink씾
1) Operating HomeLink씾
1. Press and release the desired pro
-
grammed HomeLink button (1, 2 or 3).
The HomeLink indicator (7) should light
green, solid or flashing, and your pro
-
grammed device should operate.
If your device does not operate, the
HomeLink programming was not suc
-
cessful, and you'll need to reprogram the
button.
To Next Page
Loading...
Need help?
General
