Driver assistance system
386
Blind-Spot Collision-Avoidance Assist (BCA)
Detecting sensor
[1]: Front view camera[2]: Rear corner
radar
Refer to the picture for the detailed loca
-
tion of the detecting sensors.
Take the following precautions to main
-
tain optimal performance of the detect
-
ing sensor:
僅 Never disassemble the rear corner
radar or radar assembly, or apply any
impact on it.
僅 If there is impact on the rear corner
radar or near the radar, even though
the warning message does not appear
on the cluster, Blind-Spot Collision-
Avoidance Assist may not operate
properly. In this case, have your vehi
-
cle inspected by an authorized Kia
dealer.
僅 If the rear corner radars have been
replaced or repaired, have your vehi
-
cle inspected by an authorized Kia
dealer.
僅 Use only genuine parts to repair or
replace a damaged front radar cover.
Do not apply paint to the front radar
cover.
僅 Do not apply license plate frame or
objects, such as a bumper sticker, film
or a bumper guard near the rear cor
-
ner radar.
僅 Blind-Spot Collision-Avoidance Assist
may not work properly if the bumper
has been replaced, or the surround
-
ings of the rear corner radar has been
damaged or paint has been applied.
僅 If a trailer, carrier, etc. is installed, it
may adversely affect the performance
of the rear corner radar or Blind-Spot
Collision-Avoidance Assist may not
operate.
For more details on the precautions of
the front view camera, refer to "Forward
Collision–Avoidance Assist (FCA) (Front
view camera only)" on page 6-4.
To Next Page
Loading...
Need help?
General
