85
8
8
Maintenance Light bulbs
Replacing side repeater lamp bulb
(bulb type) (if equipped)
1. Remove the lamp assembly from
the vehicle by prying the lens and
pulling the assembly out.
2. Disconnect the bulb electrical con
-
nector.
3. Separate the socket and the lens
parts by turning the socket coun
-
terclockwise until the tabs on the
socket align with the slots on the
lens part.
4. Remove the bulb by pulling it
straight out.
5. Insert a new bulb in the socket.
6. Reassemble the socket and the
lens part.
7. Connect the bulb electrical con
-
nector.
8. Reinstall the lamp assembly to
the body of the vehicle.
Replacing rear turn signal lamp /
back up lamp bulb / tail lamp / tail
and stop lamp bulb (bulb type)
(rear combination lamp type A, B)
Type A
Type B
1. Turn signal lamp
2. Back up lamp
3. Tail lamp
4. Tail and stop lamp
To place the lamp bulb:
1. Open the tailgate.
2. Loosen the light assembly retain
-
ing screws with a cross-tip
screwdriver.
To Next Page
Loading...
