M0290-01Model 4900
2-10 Rev. 8/19
TM
Machine Operation
4. (If applicable) Install PTO pump onto tractor PTO shaft. Make sure shaft rotation matches direction indicated on
pump housing.
5. If equipped with ISOBUS system, attach ISO connector.
6. For planters not equipped with ISOBUS, connect ASABE Standards 7 terminal connector for safety/warning
lights on planter to ASABE Standards receptacle on tractor. If your tractor is not equipped with an ASABE
Standards receptacle, check with your tractor manufacturer for availability. Check warning lights on planter work in
conjunction with warning lights on tractor.
7. Completely raise parking stands to prevent damage to stands and equipment when moving planter.
8. (If applicable) Connect compressor harness.
9. If equipped with True Depth, attach the True Depth 6 pin connector.
10. If equipped with Blue Drive, attach the Blue Drive 6 pin connector and Ethernet cable to the Blue Vantage display.
NOTE: A tractor model-specific PTO mount kit is required and available from Ag Power Systems, LLC (319-646-
2770 or www.agpowersystems.com) and Rowe Manufacturing (800-544-4123 or rowemfg.com).
Clean and grease PTO shaft coupling
with high-pressure industrial coupling
grease (Chevron
®
coupling grease or
equivalent) meeting AGMA CG-1 and
CG-2 Standards each time driveshaft
is installed or premature wear and
equipment failure can occur.
NOTICE
To Next Page
