MAINTENANCE CODES
(1) Hood (2) Handle
(A) Pull
U26O701A
U26O703A
H11O602A
(1) Hood (1) Side Cover (2) Hook
(A) Pull
1. The hood can be opened by pull-
ing the handle on the lower right of
it while pressing its front down.
2. To close the hood, press its front
down until it is locked in its posi-
tion.
3. Do not apply excessive force to
the handle to x it. The hood can
be damaged.
1. The side covers (LH/RH) should
be removed in order to access the
engine components.
2. Open the hood and disassemble
the rubber clips fixed on the left
and right of the side covers.
3. Remove each side cover by pulling
it forward gently while lifting it up.
4. When installing them, align their
pins to the groove on the tractor
body and press them down. Then,
x them with the rubber clips.
CAUTION
If noise is heard from the hood
during driving, check the rubber
molding and replace it if dam-
aged.
NOTE
To Next Page
Loading...
