POWER TAKE-OFF (HYDRAULIC BLOCK TYPE)
(1) To the Tank (2) Relief Valve
(3) To The Hydraulic Cylinder
(4) OUT PORT (To The Exterior Implement)
(5) IN PORT (“T” PORT Of The Exterior Implement)
(6) R PORT (
Carry-Over Port Of The Exterior Implement
)
(7) Adjusting Screw
The block type power take-off is use-
ful when attaching a hydraulic oper-
ating equipment, such as the front-
end loader and front blade.
Though the tire pressure is factory-set
to the prescribed level, it naturally drops
slowly in the course of time. Therefore,
check it everyday and inate as necessary.
(A) Insufcient (B) Standard
(C) Excessive
TIRES, WHEELS AND BALLAST
T85O530A
U26O432A
WHEN ATTACHING AN IMPLEMENT
1. Unscrew the plug.
2. Fit the hose (PT3/8") to the inlet
and outlet of the hydraulic block.
3. Turn the adjusting screw clockwise
completely to attach an implement.
When no implement is used,
turn the direction valve coun-
terclockwise completely. Other-
wise, the relief valve is operable.
IMPORTANT
Do n o t u s e t i re s lar g er o r
smaller than specied.
Do not disassemble or as-
semble the tire.
If it is neces-
sary to disassemble/assemble
the tire, let a qualied service
person perform the work.
WARNING
To Next Page
Loading...
