8
-
4
DS3510
1. Check the tire air pressure and in-
atethetiresiftheyarelow.
2. Install a fully charged battery.
3. Check the fan belt tension.
4.Checkalluidlevels.
(Engine oil, transmission/hydraulic
oil, engine coolant and any at-
tached implements.)
5. Remove grease from the exposed
cylinder rod.
6. Apply grease to the lubrication
points.
7. Remove the cover from the ex-
haust pipe.
8. Get onto the tractor and start the
engine.
9. Check if the instrument panel and
all parts operate correctly while
running the engine for a few min-
utes.
USAGE AND DISPOSAL (EN-
VIRONMENTAL CONCERNS)
In order to protect the environment,
use and dispose of the tractor keep-
ing the following in mind:
1. When changing the oil or coolant
by yourself, be careful not to spill it
and dispose used oil and coolant
properly according to the appli-
cable regulations.
2. Never leave or discard the expired
tractor or implement, but contact
your local KIOTI Dealer to dispose
it according to the regulations.
3. Avoid working under high load as it
can cause excessive exhaust gas,
which is harmful to the environ-
ment.
USING TRACTOR AFTER STORAGE
10. Drive the tractor outside and
check if it is operating properly.
Park the tractor outside and idle
engine for at least 5 minutes.
Stop the engine and visually in-
spect the tractor. Check if there
is leakage.
11. Start the engine, release the
parking brake, and check the
brake condition while driving for-
ward. Adjust the brake pedals if
necessary.
12. Stop the engine and check for
leakage. Repair any part as re-
quired.
To Next Page
Loading...
