-
-
-
CAUTION
-
-
The transmission fluid should be
changed if it is contaminated or after
the transmission is serviced or every
400 hours of operation. When chang-
ing the transmission uid, make sure
to change the fluid filter. However,
replace the filter only at initial 50
hours and every 200 hours operation
afterward.
1. Park the tractor on a level ground
and start the engine to warm it up.
2. Stop the engine, apply the parking
brake, and remove the drain plug.
U26O712A
(1) Oil Filter Cartridge
3. To drain the used uid, place the oil
pan under the transmission case
and turn the drain plug counterclock-
wise to drain the fluid completely.
If the uid does not ow out freely,
unscrew the plug on the side of the
hydraulic cylinder on the left of the
top link bracket to facilitate drain-
age. (Ref to next page) Reinstall the
drain plugs securely afterward.
4. Unscrew the fluid filter from the
rear right section on the tractor us-
ing a lter wrench.
U26O713A
(1) Drain Plug
To Next Page
Loading...
