5. Apply a thin lm of clean oil onto
the O-ring of a new lter.
6. Tighten the filter firmly until it
contacts the mounting surface.
Tighten the lter a half turn further
by hand.
7. Run the engine for a few minutes
and then stop it after installing a
new lter.
8. Check the uid level and add uid
to the specied level.
U26O715A
(1) Air Bleeding
9. Make sure that the transmission
uid does not leak through the seal.
-
CAUTION
-
-
U26O706A
(1) Oil Gauge
(A) Oil Level Is Acceptable Within Range
O aat 6.87 U.S.gal. (26 L)
To Next Page
Loading...
