(1) Engine Oil Filter
U26O711A
4. Remove the oil filter behind the
cooling fan on the right side of the
engine.
5. Apply a thin lm of oil to the O-ring
of a new filter and tighten the
O-ring rmly by hand.
6. Add the engine oil to the specied
level and tighten the oil lter to the
specied torque.
O aat th ter
1.53 U.S.gal. (5.8 L)
7. Run the start motor for approx.
10 seconds to deliver oil to each
part.
8. Run the engine for approx. 5
minutes and check if the oil warn-
ing lamp comes on. If it does not
come on.
9. Stop the engine. (It is normal that
the oil warning lamp is “OFF”
while the engine is running.
10. Check the engine oil level again
with the oil dipstick. If the level is
low, add more oil.
burnt.
-
-
WARNING
The engine oil filter should be
replaced when changing the en-
gine oil.
NOTE
To Next Page
Loading...
