H
HORN SWITCH ....................................................................4-6
HOW TO DISCONNECT THE HOOD (A) ............................7-7
HOW TO FOLD THE ROPS ...............................................5-13
HOW TO RAISE THE ROPS TO UPRIGHT POSITION .....5-14
HOW TO WARM UP ENGINE ..............................................5-8
HYDRAULIC BLOCK..........................................................6-14
I
IMPLEMENT LIMITATIONS ..................................................3-6
INDEX.................................................................................10-1
INFLATION PRESSURE ....................................................4-23
INITIAL OPERATION ............................................................5-2
INSTALLATION AND REMOVAL OF 3-POINT HITCH
IMPLEMENT (WITH PTO SHAFT) ....................................6-2
INSTALLING PTO SHAFT ....................................................6-8
INSTRUMENT PANEL ..........................................................4-8
J
JOYSTICK LEVER (COMES WITH LOADER PACKAGE) 6-11
JUMP STARTING .................................................................5-9
K
KEY SWITCH .......................................................................4-4
L
LIFTING ARM (LOWER LINK) SPEED CONTROL LEVER ..4-21
LOADING INTO AND UNLOADING OUT OF THE TRUCK ..5-19
LONG-TERM STORAGE .....................................................8-2
LUBRICANTS .......................................................................7-6
LUBRICATING GREASE FITTINGS (P) ............................7-19
M
MAIN SHIFT LEVER ..........................................................4-14
MAINTENANCE ...................................................................7-1
MAINTENANCE CHECK LIST .............................................7-3
MAINTENANCE CODES ......................................................7-7
MAINTENANCE SCHEDULE CHART .................................7-4
MOUNTING LOCATION .......................................................4-3
O
OILS AND FLUIDS ...............................................................2-4
OPERATING THE CONTROLS ........................................4-13
OPERATING THE ENGINE ..................................................5-3
OPERATING THE TRACTOR ............................................5-10
OPERATION .........................................................................5-1
OPERATION TIP FOR 3-POINT HITCH ELEMENTS ..........6-4
OTHER COMPONENTS ......................................................2-5
To Next Page
Loading...
