(1) Engine Oil Filter
6. Remove the oil filter behind the
cooling fan on the right side of the
engine.
7. Apply a thin lm of oil to the O-ring
of a new lter and tighten the new
lter rmly by hand.
8. Fill the engine oil to the specied
level and tighten the oil ller cap.
9. Run the engine for approx. 5
minutes to deliver oil to each
part.
10. Stop the engine if the oil warning
lamp still comes on. (It is normal
for the oil warning lamp to be off
while the engine is running)
11. Check the engine oil level with
the oil dipstick. If the level is low,
add more oil.
The engine oil filter should be
replaced when changing the en-
gine oil.
NOTE
The engine oil is very hot while
the engine is running or right
careful not to be burned.
Avoid oil contact while chang-
ing or adding engine oil and
eye contact.
-
tact with the engine oil may
cause skin disorders and skin
cancer. If skin contact is made,
-
sible.
of children.
WARNING
TF1O708A
4B243
7.7 L (2.03 U.S.gal.)
4F243
4FT-TM2
4FT-TP2
9.0 L (2.38 U.S.gal.)
To Next Page
Loading...
