1. Disen gage the PTO, lower all
implements, place all control le-
vers in the neutral position, set
the parking brake, stop the engine
and remove the key.
WHEN PARKING THE TRACTOR
T66O120a
(1) PTO Shaft Cover (2) PTO Shaft Cap
WHEN OPERATING THE PTO
1. Make sure the tractor is completely
stopped, gears are in neutral and
all moving components have com-
pletely stopped before connecting,
disconnecting, adjusting, cleaning
or servicing any PTO driven equip-
ment.
2. Keep the PTO shaft cover in place
at all times. Replace the PTO shaft
cap when the shaft is not in use.
3. Before installing or using PTO
driven equipment, read the man-
M55O109a
ufacturer's manual and review the
safety labels attached to the equip-
ment.
WARNING
Before driving an implement
with the PTO, always make
sure that all bystanders are
well away from the tractor.
When using the PTO drive with
a stationary tractor, always
make sure that the gears are
in neutral and that the parking
brake is applied.
Before starting up any PTO-
driven implement hitched to
the three-point linkage, lift the
implement to its full height and
check that at least 1/4 of the
total length of the telescopic
section of the drive shaft is en-
gaged.
Ensure that implements and
attachments are properly in-
stalled and that the tractor and
implement PTO RPM ratings
match.
To Next Page
Loading...
