ANTI-FREEZE
This tractor is lled with 50% of eth-
ylene glycol at factory.
If the anti-freeze has been replaced
by tap water later on, the coolant can
freeze, leading to damage to the cyl-
inder and radiator when the ambient
temperature is below zero (32 °F).
Therefore, make sure to change
water into anti-freeze before winter
season comes.
When changing the anti-freeze with
one of another type, ush the cooling
system several times and contact a
professional for the mixture ratio.
Vol. %
Anti-
freeze
°F
°C °F °C
40
50
-12
-34
-24
-37
222
226
106
108
*
At 760 mmHg pressure (Atmosph-er-
ic). A higher boiling point is obtained
by using a radiator pressure cap.
1. There is a plug under the clutch
housing.
2. Drain the water completely and
install the plug. Drain the water
into a container and dispose of it in
a proper manner for environment
protection.
3. Make sure to install the plug and
not to damage the clutch severely.
4. Make sure to drain water after
working in a paddy field and wa-
tery eld.
DRAINING WATER FROM
CLUTCH HOUSING (AJ)
(1) Drain Bolt
T11O751A
NOTE
the left are industry standards
that necessitate a minimum
glycol content in the concen-
trated anti-freeze.
only. In case of leakage, add
anti-freeze and water in the
Anti-freeze absorbs moisture.
tightly sealed container.
Do not use radiator cleaning
agents when anti-freeze has
been added to the cooling wa-
ter. (Anti-freeze contains an
anti-corrosive agent, which will
react with the radiator cleaning
agent forming sludge which
•
•
•
•
To Next Page
Loading...
