60 L (15.9 U.S.gal.)
(1) Oil Dipstick & Filler Plug
(A) Oil level is acceptable within range
before changing the fluid or
-
ly. You can get burned by hot
•
•
CAUTION
the hydraulic system, use only
heavy load right after chang-
damage to the hydraulic sys-
tem.
•
•
5. Apply a thin lm of clean oil onto
the O-ring of a new lter.
6. Tighten the lter rmly by hand.
7. Run the engine for a few minutes
and then shut engine off to check
for leaks and uid level. Add uid
to the specied level as needed.
(1) Oil Filler Plug
OIL (M1)
1. Remove the filling plug from the
front axle.
2. Check the oil level with the level
gauge of the ller plug.
3. If the oil level is too low, add new
oil to the allowable level.
M55O757A
T11O702A
To Next Page
Loading...
