10. Use a floor jack of suitable ca-
pacity and apply them at the
centre of the front and rear axles
while paying due attention to
weight distribution.
11. No decals for the lifting point are
applied on the tractor, as they
would be, too difcult to apply in
the available spaces and would
be all too easily removed or ef-
faced during normal operation of
the tractor.
M55O115aM55O114a
7. If the tractor must be lifted for
servicing, take it to a suitably
equipped workshop.
8. Carry out the following operations
before any operation of the tractor:
Engage the four-wheel drive, the
first gear and the parking brake
and put cho cks to the whee ls
touching the ground.
9. Before lifting the tractor, prevent it
from swinging by means of wooden
wedges applied to the front axle.
This engine is coated with an-
ti-corrosive to prevent prema-
ture corrosion. This coating
on hot components, includ-
ing the exhaust manifold and
turbocharger, may be deterio-
rated by high heat during use,
resulting in loss of its effect.
Therefore, such areas may be
corroded in course of time.
•
NOTE
To Next Page
Loading...
