EasyManuals Logo

KITO ER2 Series User Manual

KITO ER2 Series
144 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
33
Do not use the Friction Clutch to measure the weight of a load.
The use of the Friction Clutch other than intended purpose may result in injury or property damage.
Prohibited
When carrying a lifted load using a lifting magnet or a vacuum chuck, lower the height of the
lifted load as low as possible.
When lifting a load with two electric chain hoists, use the electric chain hoist with the rated lifting
capacity of a single hoist exceeding the load.
When lifting a load with two electric chain hoists, use the electric chain hoists of the same model
and capacity and operate the respective electric chain hoist to keep the load lifted or lowered
horizontal.
Failure to comply with this instruction causes bodily injury or loss of property.
Mandatory
CAUTION
In Abnormality or Failure
If the electric chain hoist is damaged or abnormal noise or vibration occurs, stop the operation
immediately.
If the electric chain hoist moves in the direction opposite to the indication on the Push Button
Switch, stop the operation immediately.
When the twist, entanglement, crack, deformation, attachment of foreign matters or abnormal
engagement of the Load Chain and the Gear is observed, stop the operation immediately.
When any abnormality is observed during the operation, indicate “FAILURE" and contact with
the maintenance engineers.
When the power is interrupted, secure safety and contact with the maintenance engineers.
Failure to comply with these instructions may result in death or serious injury.
Mandatory
Do not impede the lifted load with other structure or wiring.
Failure to comply with this instruction causes bodily injury or loss of property.
Prohibited
If the Load Chain and the hand chain of the geared trolley are entangled, stop the operation
immediately and reset the entangled chains.
Failure to comply with this instruction causes bodily injury or loss of property.
Mandatory
CAUTION
Traverse / Travel
Do not operate the electric chain hoist underneath the load or transport a
load over people. (Fig. I)
Do not operate the electric chain hoist when any person is in the area
where the lifted load moves.
Do not allow people to enter into the area where a lifted load moves.
Do not ride on a lifted load and do not use the electric chain hoist to
support, lift, or transport people. (Fig. J)
Do not strike the stopper or the structure by the body size or the
trolley.
Do not operate or move the electric chain hoist while going backward with a load
kept lifted.
Operate the electric chain hoist while looking forward from the back of a load and going ahead.
Failure to comply with these instructions may result in death or serious injury.
Prohibited
I J
How to Use Operation
1
(to be continued)
DANGER
DANGER

Table of Contents

Other manuals for KITO ER2 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KITO ER2 Series and is the answer not in the manual?

KITO ER2 Series Specifications

General IconGeneral
Control Voltage24V
Duty Cycle40% ED
Protection ClassIP55
Temperature Range-20°C to +40°C
TypeElectric Chain Hoist
Frequency50/60 Hz
Motor InsulationClass F
Brake TypeElectromagnetic
Load Chain GradeGrade 80
Ambient Temperature-20°C to +40°C
Power Supply3-phase
Lift Height3 to 30 meters
Chain Falls1 or 2
Voltage200-240V, 380-480V

Related product manuals