EasyManuals Logo

KITO ER2 Series User Manual

KITO ER2 Series
144 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #35 background imageLoading...
Page #35 background image
35
Prohibited
CAUTION
Do not store the electric chain hoist at a state of over lifting or over lowering.
Failure to comply with these instructions causes bodily injury or loss of property.
NOTE
Clean the push buttons always not to allow the dust and sands attach.
When storing the electric chain hoist for a long period, it is effective to prevent rusting to operate it at a certain
period without load.
When putting the electric chain hoist on a floor, remove the Chain Container.
Otherwise the Chain Container may deform or be damaged.
When not using the electric chain hoist, wind up the Bottom Hook to the height not to hinder persons passing by or
other work.
Decide the place to store the electric chain hoist in advance. It is recommended to hang the push button set
on the pillar.
Precautions After Work
Store the electric chain hoist with power off.
Indicate “FAILURE" on the electric chain hoist that needs repair not to be used.
Wipe off dust and waterdrop, apply oil at the neck of the Hook and the Load Chain and store the
hoist.
Remove the stain, attached foreign matter and waterdrop from the parts such as the Limit Switch
and the Chain Container that is scratched by the Load Chain or stored it.
When the electric chain hoist is installed outdoor, cover it with rain cover or roof after application
of rust proof process.
Failure to comply with these instructions causes bodily injury or loss of property.
Mandatory
How to Use Precautions After Work
1

Table of Contents

Other manuals for KITO ER2 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KITO ER2 Series and is the answer not in the manual?

KITO ER2 Series Specifications

General IconGeneral
Control Voltage24V
Duty Cycle40% ED
Protection ClassIP55
Temperature Range-20°C to +40°C
TypeElectric Chain Hoist
Frequency50/60 Hz
Motor InsulationClass F
Brake TypeElectromagnetic
Load Chain GradeGrade 80
Ambient Temperature-20°C to +40°C
Power Supply3-phase
Lift Height3 to 30 meters
Chain Falls1 or 2
Voltage200-240V, 380-480V

Related product manuals