EasyManuals Logo

KITO ER2 Series User Manual

KITO ER2 Series
144 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #93 background imageLoading...
Page #93 background image
93
Chapter 3
Troubleshooting
Guidance on Troubleshooting ........................................................ 94
Safety Precautions ..........................................................................98
Troubleshooting...............................................................................99
• Power .............................................................................................99
• Circuit breaker ..............................................................................99
• Power Cable ................................................................................100
• Motor ............................................................................................101
• Brake ............................................................................................102
• Internal wiring .............................................................................104
• Transformer .................................................................................104
• Electromagnetic Contactor, Relay ............................................105
• Fuse .............................................................................................105
• Upper/Lower Limit Switch .......................................................... 106
• Noiselter ...................................................................................106
• Push Button Switch ....................................................................107
• VFD ............................................................................................... 108
• Interface Board ...........................................................................108
• Braking Resistor .........................................................................108
• Electric shock .............................................................................109
• Friction Clutch ............................................................................109
• Friction Clutch with Mechanical Brake .....................................110
• Hook ............................................................................................. 111
• Load Chain ..................................................................................113
• Load Sheave, Idle Sheave ..........................................................115
• Chain Guide A .............................................................................115
• Gears and Joints .........................................................................115
• Bearing ........................................................................................116
• Traveling motion of the Trolley ..................................................116
This chapter describes the main failure cause and inspection items based on the
fault conditions. The repair work (and maintenance work as well) of the electric
chain hoist is accompanied with disassembling/assembling work. Refer to the
separate “Disassembling/Assembling Manual” for the correct work.

Table of Contents

Other manuals for KITO ER2 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KITO ER2 Series and is the answer not in the manual?

KITO ER2 Series Specifications

General IconGeneral
Control Voltage24V
Duty Cycle40% ED
Protection ClassIP55
Temperature Range-20°C to +40°C
TypeElectric Chain Hoist
Frequency50/60 Hz
Motor InsulationClass F
Brake TypeElectromagnetic
Load Chain GradeGrade 80
Ambient Temperature-20°C to +40°C
Power Supply3-phase
Lift Height3 to 30 meters
Chain Falls1 or 2
Voltage200-240V, 380-480V

Related product manuals