KITO ER2 Series User Manual

61
Check after Installation
■
Check items
Make sure that the following are satisfied:
• No bolt, nut nor split pin is lost. Tightening and assembling are completed.
• Protection Wire for Push Button Switch Cord is securely tied to accept and endure the force instead of Push
Button Switch Cord when the Push Button Switch Set is drawn.
• The Power Cable is fixed to the Cable Support.
• Source voltage is the rated voltage
• Grounding Wire (earth wire) is connected securely.
● When using with a Trolley
Check the following:
• The electric chain hoist and the trolley are combined correctly.
• The stoppers for trolley are securely mounted to Travel Rail where the Trolley travels.
• The surface of Travel Rail is not attached with paint or oil. (The surface of the Travel Rail must be basis metal. Do
not paint.) There is no obstacle for the trolley to travel. The Travel Rail is set to a level.)
■
Operational Check
Carry out the operational check in accordance with Daily inspection (P20).
Wrong assembling or installation causes death or serious injury. To prevent such danger check the following.
Check after Installation
1

KITO ER2 Series Specifications

General

Control Voltage	24V
Duty Cycle	40% ED
Protection Class	IP55
Temperature Range	-20°C to +40°C
Type	Electric Chain Hoist
Frequency	50/60 Hz
Motor Insulation	Class F
Brake Type	Electromagnetic
Load Chain Grade	Grade 80
Ambient Temperature	-20°C to +40°C
Power Supply	3-phase
Lift Height	3 to 30 meters
Chain Falls	1 or 2
Voltage	200-240V, 380-480V