7 Appendix
7.1 Transport, storage, maintenace, disposal
Transport: — only by qualified personnel
— only in the manufacturer’s original recyclable packaging
— avoid shocks
— temperature -25 to +70°C, max. rate of change 20°C/hour
— humidity max. 95% relative humidity, no condensation
— the servo amplifiers contain electrostatically sensitive components
— which can be damaged by incorrect handling. Discharge yourself
— before touching the servo amplifier. Avoid contact with highly
— insulating materials (artificial fabrics, plastic films etc.).
— Place the servo amplifier on a conductive surface.
— if the packaging is damaged, check the unit for visible damage.
— In such a case, inform the shipper and the manufacturer.
Packaging: — recyclable cardboard with inserts
— dimensions SERVOSTAR 4xxA (HxWxD) 100x300x270 mm
SERVOSTAR 4xxM (HxWxD) 150x300x270 mm
— labelling instrument label on outside of box
Storage : — only in the manufacturer’s original recyclable packaging
— the servo amplifiers contain electrostatically sensitive components
— which can be damaged by incorrect handling. Discharge yourself
— before touching the servo amplifier. Avoid contact with highly
— insulating materials (artificial fabrics, plastic films etc.).
— Place the servo amplifier on a conductive surface.
— max. stacking height: 8 cartons
— storage temp. –25 to +55°C, max. rate of change 20°C/hr
— humidity relative humidity max. 95%, no condensation
— storage duration < 1 year without restriction
> 1 year: capacitors must be re-formed before
the servo amplifier is commissioned.
To do this, remove all electrical connections and
supply the servo amplifier for about 30 min. from
230V AC, single-phase, on terminals L2 / L3.
Maintenance: — the instruments do not require any maintenance
— opening the instruments invalidates the warranty
Cleaning : — if the casing is dirty : cleaning with Isopropanol or similar
do not immerse or spray
— if there is dirt inside the unit : to be cleaned by the manufacturer
— dirty protective grill (fan) : clean with a dry brush
Disposal : — you can dismantle the servo amplifier into its principal components
— by screwing it apart (aluminium heat sink, steel housing sections,
— electronics boards)
— disposal should be carried out by a certified disposal company.
— We can give you suitable addresses on request.
SERVOSTAR
®
400 Installation Manual 67
Kollmorgen 07/05 Appendix
To Next Page
Loading...
Need help?
General
