KOMPATTO KH0623 - Page 12

12
2. Instructions for use
2.2. Preliminary information
The control panel of the oven is equipped with a single dial M (g. 9)toinsertormodifythe
operating parameters of the appliance. This knob can also be pressed to select a function or con-
rmacertainparameter.Thedialactsuponadigitalencoderand,therefore,ithasacontinuous
rotation(thereisnolimitswitch).Theparameterssetviatheencodervary:clockwise(increase)
orcounterclockwise(decrease).
At this point the oven is ready for use, in "stand-by" mode, waiting for user input.
The lighting time inside the cooking chamber varies depending on the value set (see section
6.4. Page 31).Iftheoven'sdoorisopened,thelightingsystemshutsdowntemporarily;when
the door is closed, the lights turn on again.
The T2 Start/Stop key can either start a cooking cycle or end a cooking cycle in progress. If the
cooking cycle is interrupted prematurely using the key T2, no sound warning is generated. This
key also silences the cooking cycle end signal.
After switching off the oven by pressing and holding down the master switch T1, the water shut-
off valve located upstream of the unit will be closed.
When turning off the oven, it may happen that the ventilation of the technical compartment at
thetop,abovethecookingchamber,isrunningcontinuouslytonishthecoolingcycle.