KOMPATTO KH0623 - Cooking with Rack Control

20
230°
START
ALL
5
6
4
3
2
1
3. Manual setup
3.10. Multilevel cooking with RACK CONTROL
Select the RACK CONTROL mode pressing
the relative key S7g. 27;
Note: The key S7 will be displayed only if the
time S3issettoinnite(INF).
Once the oven is set to RACK CONTROL
mode, you can set the time or core probe tem-
perature up to 6 values in relation to the vari-
ous levels present inside the oven.
Example:
• level 1 = 10 minutes
• level 3 = 60°C core probe
• level 4 = 7 minutes
Set the timer or core probe temperature to the
desired level by selecting the relative level. A
pop-up will be displayed, enabling you to se-
lect the timer (a)orcoreprobe(b)mode.Se-
lect the desired mode, and set the value by
turning the dial M. Conrm by pressing the
dial M or the pop-up.
ON the left side of the screen it is possible to
set or modify the cooking parameters (mode,
temperature,fan,etc.)
THE RACK CONTROL can be used in two
different modes:
• with oven in STOPmode(programming);
• with oven in START mode (cooking al-
readystarted).
Setting the values of various levels with the
oven in STOP mode; one you have pressed
the Start button (T2 page 9) the ovenwill
start cooking with the values set for: cooking
mode, temperature, etc. .. set (with the rela-
tive automatic pre-heating cycle, if set). The
operator should then manually start the timer/
control of core temperature for each level by
pressing on the pan icon ( )relatedtothe
desired level. When a level has been activated
the icon will turn red .
YOU can start all the levels at once by pressing
the corresponding key S13 g. 29.
If you use the RACK CONTROL mode, in-
stead, with the oven set to START, after you
have set the timer or core probe temperature
value, the dedicated control will start automat-
icall,onceyouhaveconrmedthevalueset.
Upon reaching the set core temperature or at
the end of the time set on the relative level,
on display appears the writing END and the
oven emits an acoustic signal. At this point you
MEM
PRE
HEAT
180°
INF
Manuale Fase 1/1
Dom 02-10-15 20:32
g. 27
a
b
230°
START
ALL
5
6
4
3
2
1
0:05
55°
S7
S3
S13
g. 28 
g. 29 