KOMPATTO KH0623 - Preliminary Information

11
KOMPATTO installation, use and maintenance manual
The appliance was designed to cook food indoors and should only be used for this function:
any other use should be avoided as it is considered improper and dangerous.
During operation, supervise the appliance.
Before cooking, run a pre-heating cycle for the oven at a temperature of about +30 ° / +40
° C higher than necessary.
The"touch-screen"ttedontheovenprovidesquickandintuitiveaccesstoallfunctions.The
parameters and settings of each function can be set by choosing the function on the display,
selecting the desired value by turning the dial Mandconrmingthisvaluebypressingthe
button or the dial M. By pressing the dial M you can silence the alarms.
When switched on, the display shows the main menu where you can choose between
manual
cooking
,
recipes
,
service
or
regeneration
* (*forKHmodelsonly).
2. Instructions for use
2.1. Identication of controls
T1: STARTUP AND SHUTDOWN
it allows you to turn the oven on and off by pressing it for a few seconds.
T2: START/STOP KEY
it enables starting and stopping the cooking cycle. This key can be:
on
: cooking in progress;
off
: cooking not in progress or stopped;
flashing
: cookingisinwaitingstate(dooropen,errormessagesorconrmation
ofoperations).
T3: ESC KEY:
it allows the user to return to the previous page.
T4: MENU KEY:
it enables the user to return to the main menu.
T5: LIGHTING KEY:
to turn on the lighting system in the cooking chamber.
TS: TOUCH SCREEN:
touch screen. The operating parameters of the appliance are set and displayed on this
screen.
M: DIAL WITH ENCODER:
The dial is used to set the values on the screen. If the dial is pressed, the value en-
teredisconrmed.
2.2. Preliminary information