If an alarm is triggered, on temperature and time display is shown the name of the alarm trig-
gered.
The alarms managed are the following
Name Description Actions SOLUTION
Chamber
probe
Chamber probe
failure
Cooking cycle
block; automatic
reset.
Replace the chamber probe.
Pin
probe
Pin probe failure Manual reset. Replace the pin probe.
Safety
motor
Motor Alarm Cooking cycle
block; automatic
reset.
If the problem persists, contact the
support center.
Peripheral Motor Inverter Alarm Cooking cycle
block; automatic
reset.
Cut off the power and power again.
If the problem persists, contact the
support center.
Chamber
safety
switch
Chamber thermal
breaker
Cooking cycle
block; automatic
reset.
If the problem persists, contact the
support center.
Hi temp Temperature inside
the technical
compartment is too
high
Cooking cycle
block; automatic
reset.
Check the perimeter of the oven
(slits)andthecorrectoperationof
parts cooling fans.
Clean the ventilation lter (see
section 7.2 page 36).
No
water
There is no water to
generate steam
Cooking cycle
block; automatic
reset.
Check the connection to water
pipeline and make sure the shut-off
valve is open.
Communi-
cation
Main board
communication
failure
Cooking cycle
block.
Cut off the power and power again.
If the problem persists, contact the
support center.
No drain The water in the
boiler is not drained
correctly
Cooking cycle
block.
Cut off the power and power again.
If the problem persists, contact the
support center.
Power fail Electric power supply
is interrupted
Cooking cycle
block.
Press M for 1 second.
Probe 4 Moisture control
probe 4 alarm
Cooking cycle
block.
Replace the moisture control probe 4
Probe 5 Moisture control
probe 5 alarm
Cooking cycle
block.
Replace the moisture control probe 5
10. Alarms description
To Next Page
Loading...