4
g. 1
1. Installation
1.1. General safety warnings
Before putting the appliance into service,
check that you have removed all parts of the
package, disposing of the latter in accord-
ance with current legislation.
Any change to oven installation that could
become necessary should be approved and
carried out by authorized technical staff.
The appliance is intended to be used exclu-
sivelyforprofessionaluse,byqualiedstaff
It is strictly forbidden to carry out any kind
ofmodicationstoovenwiring.
Failure to comply with the above instructions
can compromise the safety of the equipment
and yours, too.
When the cooking is hot, be careful when
you open the door. DANGER OF
BURNS!!
The equipment complies with the essential requirements of the Low Voltage Directive 2006/95/EC.
It meets the provisions of the following electrical standards:
EN 60335 general part;
EN 60335-2-42;
The equipment complies with the essential requirements of the Electromagnetic Compatibility Direc-
tive 2004/108/EC.
1.2. Positioning
The appliances have been designed to be installed indoors and cannot be used outdoors neither be
exposed to rain.
Thelocationdesignatedforoveninstallationshoulthaveasolid,atandhorizontalsurface,able
to safely support both the weight of the ap-
pliance-support group and that the maximum
rated load.
The appliance must be placed in a suitably ven-
tilated room to prevent harmful the excessive
accumulation of harmful substances in the air.
The oven should be installed exclusively on a
stable support.
Unpack the appliance and make sure it is intact.
Arrange the operation area being careful not to
place it on top of or against walls, bulkheads,
partition walls, partitions, kitchen furniture or
coatingmadeinammablematerial.
We recommend you strictly comply with re-
prevention regulations in force.
To Next Page
Loading...