Konica Minolta CA-410 - Page 50

48
Display Screen
(3)-2. Single-Probe Display
Trigger mode 0-cal AUTO
1.0
y
0.0 0.2 0.4 0.6 0.8 1.0 x
0.2
0.6
0.4
0.8
Measuring
10
09
08
07
06
05
04
03
02
01
Lv
x
y
160.00
0.3127
0.3293
Φ10 Mini Normal
CH-01 f:Factory
ID: abcdefghij
Save
MeasSpeed
: LTD.AUTO
Sync
: MANU. (100. 0ms)
cd/ ㎡
Probe information
Graph
Measured values
Data display area
• Selecting the number of a connected port using the [UP/DOWN] keys displays only the data measured by the probe
connected to that port.
• The probe information display shows the information of the selected probe.
Type: Probe type
Selected calibration CH: CH00 to CH99
Calibration type: f:factory KM factory calibration
s:user single User calibration (single-point calibration)
m:user matrix User calibration (RGB+W matrix calibration)
c:user custom User calibration (with specified calibration coecients)
ID: ID set for the probe (half-width alphanumerics and symbols, 10 characters max., blank when
not set)
(3)-3. Multi-Probe Display
10
09
08
07
06
05
04
03
02
01
Save
MeasSpeed
: LTD.AUTO
Sync
: MANU. (100. 0ms)
Measuring
Lv
160.00
160.00
--.----
160.00
160.00
160.00
--.----
160.00
160.00
160.00
0.3127
0.3127
--.----
0.3127
0.3127
0.3127
--.----
0.3127
0.3127
0.3127
0.3293
0.3293
--.----
0.3293
0.3293
0.3293
--.----
0.3293
0.3293
0.3293
CH-01 Φ10MiniN abcdefghij f
CH-01 Φ10MiniN abcdefghij f
----- --- ---------- -
CH-01 Φ10MiniN abcdefghij f
CH-01 Φ10MiniN abcdefghij f
CH-01 Φ10MiniN abcdefghij f
----- --- ---------- -
CH-01 Φ10MiniN abcdefghij f
CH-01 Φ10MiniN abcdefghij f
CH-01 Φ10MiniN abcdefghij f
x ycd/m
2
Trigger mode 0-cal AUTO
Data display area
Probe information
Displays the data measured by multiple probes and the information of the probes.
Switching to single-probe display will display only the data measured by the selected probe.