Subject to errors and technical changes!
Labormaster Version 2.6.3 SW 2.2 from 03/2016 Page 11 of 82, March 1, 2016
Use").
Pacemakers, defibrillators) can most likely be excluded.
It therefore corresponds to the state of the art and enables the highest level of safety during operation. However, security
can only be implemented in operational practice if all necessary measures are taken. It is the operator's duty of care to plan
these measures and monitor their execution.
• The operator must ensure in particular that
2.1.1.
• Non-ionizing radiation
Obligations of the operator
• All safety and warning notices attached to the sealing device are not removed and
are legible.
Non-ionizing radiation is not specifically generated, but is simply emitted for technical reasons by
electrical equipment (e.g. electric motors, power lines or magnetic coils). In addition,
the device does not have strong permanent magnets. If a safety distance (distance from field source to
implant) of 30 cm is maintained, active implants (e.g.
The sealing device was designed and built after careful selection of the harmonized standards to be complied with, as
well as other technical specifications.
Only carry out maintenance work with the mains plug unplugged!
Seal seam strength tester Labormaster HCT 3000
A specialist is someone who, based on their specialist training, their knowledge and experience as well as their
knowledge of the relevant regulations, can assess the work assigned to them, recognize possible dangers and take
appropriate safety measures.
Operating instructions and technical description
• The sealing device is only operated in perfect, functional condition. • The operating instructions are
legible and complete and are available at the location where the sealing device is used.
2.1.2.
Page - 11 -
A specialist must know and comply with the relevant subject-specific rules.
• Only qualified and authorized personnel operate, maintain and repair the sealing device and the components to be
processed are correctly prepared and instructed and are familiar with the operating instructions and the
safety instructions contained therein.
Qualifications of the staff
• The sealing device is only used as intended (chapter “3.4 Intended use
Commissioning, operation, repair and maintenance (including maintenance and care) require basic mechanical and
electrical knowledge as well as knowledge of the associated technical terms. In order to ensure operational
safety, these activities may only be carried out by an appropriate specialist or an instructed person under the supervision of
a specialist.
Ulmer Straße 51 – 53
E-Mail: sales@kopp-online.de
Fax +49.7153.9510-100
Inh. Ludwig P. Goals
Phone +49.7153.9510-0
Packaging systems
D-73262 Reichenbach/Fils
Willi Kopp e. K
http://www.kopp-online.de
Machine Translated by Google
To Next Page
Loading...
Need help?
General