6.Maintenance
E-Mail: sales@kopp-online.de
Ulmer Straße 51 – 53
Willi Kopp e. K
http://www.kopp-online.de
D-73262 Reichenbach/Fils
Packaging systems
Phone +49.7153.9510-0
Inh. Ludwig P. Goals
Fax +49.7153.9510-100
If necessary, wear protective gloves.
You must not spray the device with the water hose or high-pressure cleaner.
Caution:
Never use harsh cleaning agents or hard objects.
The replacement of wearing parts and repair work may only be carried out
by qualified persons.
Cleaning the case
Before starting work, switch off the mains isolating device (main switch) and
pull out the mains plug!
Clean the housing regularly with a soft cloth.
Seal seam strength tester Labormaster HCT 3000
Operating instructions and technical description
Never loosen sealed screws.
Page - 58 -
6.1.1.
Only carry out repair and assembly work when the device has cooled down.
Under no circumstances should the device be immersed in or come into contact with water or
other liquids.
Always install the finger protection after carrying out any service work
(finger protection p. 12). The device must not be operated without this finger
protection!
6.1. cleaning
Labormaster Version 2.6.3 SW 2.2 from 03/2016 Page 58 of 82, March 1, 2016
Subject to errors and technical changes!
Machine Translated by Google
To Next Page
Loading...
Need help?
General