4.4. Installation of the protective device
4.3. Set up the device
Subject to errors and technical changes!
Labormaster Version 2.6.3 SW 2.2 from 03/2016 Page 26 of 82, March 1, 2016
Connect keyboard
Page - 26 -
Note: Never disconnect the USB storage while data is being transferred.
Operating instructions and technical description
Seal seam strength tester Labormaster HCT 3000
4.3.1.
To connect a USB storage device, connect it to the “MEMORY” socket
X4
4.3.2. Connect USB storage
The device must be attached to a stable, tilt-proof work table or the mobile equipment trolley available
as an accessory! Failure to observe this can result in the risk of injury and damage to the sealing device!
To connect the included keyboard, connect the USB cable to the “KEYBOARD” socket X3
Figure 10 / Interfaces
D-73262 Reichenbach/Fils
Figure 11 / Protective cover
E-Mail: sales@kopp-online.de
Inh. Ludwig P. Goals
Captive discs
Fax +49.7153.9510-100
Packaging systems
8 x M6 screws included
Phone +49.7153.9510-0
Ulmer Straße 51 – 53
Willi Kopp e. K
http://www.kopp-online.de
Machine Translated by Google
To Next Page
Loading...
Need help?
General