Kopp Labormaster HCT 3000 User Manual

Packaging systems
D-73262 Reichenbach/Fils
Ulmer Straße 51 – 53
Willi Kopp e. K
E-Mail: sales@kopp-online.de
http://www.kopp-online.de
Fax +49.7153.9510-100
Inh. Ludwig P. Goals
Phone +49.7153.9510-0
2.3. The definition
Start of the set sealing time. Is determined depending on the sealing strength.
The main switch is RED-YELLOW and is to be used as an emergency stop in an emergency or in
case of danger.
Can be set on the Labormaster as an absolute value or as a percentage of the set sealing force.
The sealing pressure is calculated
2.3.4. Sealing force threshold
2.3.7. sealing temperature
2.2.6. Swinging the testing device in/out
Main switch with emergency stop function
Duration of sealing force effect
2.3.6. Seal printing
The sealing pressure depends on the actual contact surface of the seal.
Page - 13 -
2.3.3. Starting point sealing time
(P=pressure [bar] / F=force [N] / A=area [cm2 ])
Seal seam strength tester Labormaster HCT 3000
2.3.1. Heat sealing
Operating instructions and technical description
2.3.5. Sealing power
2.3.2. Seal time
2.2.5.
A connection of the thermoplastic coating of substrates created by pressure or heat and pressure
Force with which the sealing rail surfaces act on the packaging materials during the sealing process.
Temperature that affects the packaging materials during the sealing process
The swiveling in and out movement (of the testing device) may only be operated at a maximum of
3.5 bar - risk of accident. To cancel the swiveling process, press the home position button (Figure 14 /
Control panel, page 30). The entire process is stopped and the testing device swings back to the starting
position.
Limit value for the starting point of the sealing time.
Labormaster Version 2.6.3 SW 2.2 from 03/2016 Page 13 of 82, March 1, 2016
Subject to errors and technical changes!
Machine Translated by Google

Kopp Labormaster HCT 3000 Specifications

General

Brand	Kopp
Model	Labormaster HCT 3000
Category	Laboratory Equipment
Language	English