Subject to errors and technical changes!
Labormaster Version 2.6.3 SW 2.2 from 03/2016 Page 12 of 82, March 1, 2016
2.2. Protective measures
Finger protection
2.2.4. To avoid damage
Ideal for storage: the rail case available as an accessory.
The two-part metal sealing jaw cover serves as finger protection. The gap between
the upper and lower finger guards is factory adjusted to 6 mm.
• Please note when using PTFE-coated sealing bars:
Personal protective equipment
Page 12 -
• Secure the device against the risk of tipping or falling before using it for the first
time. The device must be placed on a suitable, stable and tilt-proof work table
or on the equipment trolley available as an accessory.
Rails, this destroys the plane parallelism.
• You should handle removed sealing rails with care and pack them carefully
The respective operator is responsible for the internal and other transport of the sealing device
and must ensure compliance with safety regulations and accident prevention regulations.
Any sharp-edged device or cladding parts must be defused using suitable covers (cushioning
material). Transport must be slow, controlled and without collision with other objects. If
transported incorrectly, there may be a risk of injury!
2.2.3.
store.
Seal seam strength tester Labormaster HCT 3000
(such as gloves, work shoes, safety glasses, work suits, etc.).
Operating instructions and technical description
The surface of the sealing rails is manufactured with high precision and optimal
quality:
2.1.3. Transport
2.2.2.
Stability of the device
• Be sure to avoid placing hard objects between the
PTFE has a limited temperature resistance of approx. 250 °C. Higher temperatures
can destroy the coating on the rails.
2.2.1.
Be sure to always install the finger guard after any service work has
been carried out. The device must not be operated without this finger protection!
The operator must provide any necessary personal protective equipment
D-73262 Reichenbach/Fils
http://www.kopp-online.de
E-Mail: sales@kopp-online.de
Ulmer Straße 51 – 53
Inh. Ludwig P. Goals
Fax +49.7153.9510-100
Packaging systems
Phone +49.7153.9510-0
Willi Kopp e. K
Machine Translated by Google
To Next Page
Loading...
Need help?
General