6.5.
Decommissioning and disposal
6.4. Fix faults yourself
Subject to errors and technical changes!
Labormaster Version 2.6.3 SW 2.2 from 03/2016 Page 63 of 82, March 1, 2016
Sealing jaws heat significantly
above the set level
or the start button
Test device does not swing. Device is not in basic position.
Sensor defective or
Operating instructions and technical description
Sealing jaws do not close
Sealing jaws do not heat
If you wish to part with the device, dispose of it in accordance with current local regulations or send the device back
to us at no charge to us. Do not dispose of with household waste!
Replace sensor or
No compressed air.
Replace solenoid valve or just coil.
Press the home position button or
see “Swinging the test device in/out”
p.13
Cause of error
Solenoid valve without voltage
Switch off the device immediately
and allow the rails to cool down.
Insertion position at the
See "Compressed air connection"
page 27"
Page - 63 -
setpoint
when the foot switch is pressed
Seal seam strength tester Labormaster HCT 3000
Heating of the sealing jaws
switched off
Switching cam on
shaft coupling not adjusted.
Dispose of the packaging according to local regulations.
Readjust switching cam.
Too little compressed air
See “Switching off the heating of the
sealing jaws”, page 35
Press the home position button or
see “Swinging the test device in/out”
p.13
Fix the error
Insert the temperature sensors into
the hole on the sealing jaw
and attach the leaf springs to press the
temperature sensors into
the bottom of the hole.
Temperature sensor is not
positioned correctly or is outside
the sealing jaw.
Mistake
Device not in basic position
Clamping roller not reached
Packaging systems
D-73262 Reichenbach/Fils
Phone +49.7153.9510-0
Inh. Ludwig P. Goals
Fax +49.7153.9510-100
E-Mail: sales@kopp-online.de
Ulmer Straße 51 – 53
Willi Kopp e. K
http://www.kopp-online.de
Machine Translated by Google
To Next Page
Loading...
Need help?
General