2/ Replacing an Effect
Replacing PL1 In program I 99
The A1 allows you to freely substitute effects in programs with others, as long as the
other effects can fit into the respective effect box.
1. Display EDIT SELECT by following steps 1 to 3 on page 12.
2. Press the PAGE + key,
"CHAIN EDIT" is shown on the display. Now you can replace an effect with
another.
Replacing "PL1" Plate Reverb
with "CHO
11
Chorus
3. Select a new affect by turning the double edit control under the desired affect.
For example, replace "No.1 PL1 Plata Reverb" with "No.22 CHO Chorus" by
turning the "E" double function edit control.
After turning the "E" double function edit control, you may also find the desired effect by
scanning them one at a time with the UP/DOWN keys.
Refer lo "EFFECTS AND PARAMETERS" In find the effect order and number.
4. Similarly, replace one effect with another by turning the other double
function edit controls.
To save the edited program:
In the Write Mode, store the edited program in memory (see page 40). A program that
has just been edited will return unaltered lo its original form if you select another
program without executing the write operation.
3/ Creating a New Program
The procedure far creating a new program is outlined below. For the details, refer to
"The Edit Mode" on page 22.
1. Selecting 3 Chain
Select one type of chain, (ram the five types (Serial. Parallel, etc).
For the chain selection procedure, and the types of chains, refer to "Chain Edit" on
page 23.
2. Selecting an Effect
Place the effects to be used in the boxes of the selected chain. Refer to "Replacing
Effects" on page 26.
3. Setting effect parameters
Set a series of parameters that create the effect sound you want to have. Refer to
"Effect Edit" on page 30.
To Next Page
Loading...
Need help?
General
