4 Mapping Programs
Map Edit
This function allows you to edit the program assignment in the Map Play mode (see pa{ \7), Map
Play allows you to reorganize programs for performance or remap incoming MIDI programs to A1
internal programs.
1. Press the Utility Mode key to display the Global Utility Menu.
2. Press the "E" double function edit control [MAP].
The first map number (00) of the Map Edit mode Is displayed.
3. Rotate the "D" double function edit control [INT] to select "INT" or "CARD" for the
source of the program to be set to map number 00.
Select "INT" for an At internal program, or "CARD* for a program stored on memory card.
4. Rotate the "E" double function edit control to select the program to be assigned map
number 00.
The UP/DOWN keys may also be used to select the program number.
5. Rotate the "C double function edit control, or press the "A" or "B" double function
edit control to select the next map number.
6. Repeat steps 3 to 5 to enter the remaining programs.
7. After the program settings have been completed, press the "H" double function edit
control [EXIT] to return to the Global Utility Menu.
8. In Play Mode, press the Map key lo select Map Play.
This allows you to call back each program in the order they were entered.
MAP Initialization
The A1 was shipped with internal programs I 00 to I 99 set to Map numbers 00 to 99.
When the Initialization procedure is done the Map is reset to this configuration.
1. Press the PAGE+ key while In the MAP EDIT page.
2. Press the "F" double function edit control [INT].
3. "Are you sure?" Is displayed. Answer yes by pressing the "G" double function edit
control.
4. Press the "H" double function edit control [EXIT] to return to the Global Utility Menu.
To Next Page
Loading...
Need help?
General
