Setting the Dynamic Amount
The Dynamic Amount setting determines how much control range [he external
controller, (Dynamic Source), has over the effect parameter, {Dynamic Parameter).
Selecting a positive or negative value for the Dynamic Amount specifies the direction
in which the parameter value (Dynamic Para mater) changes.
The diagrams below show the range of Dynamic Modulation control at different
Dynamic Amount settings (positive and negative).
When the Dynamic Amount Is set to a
positive value
MAX
Dynamic Parameter
When the Dynamic Amount Is sat to a
negative value
As shown above, with a Dynamic Amount of +100, a PEDAL, for example, will sweep
the Dynamic Parameter from a 0 value to the level set in the parameter edit mode. A
value less than +100 will decrease the control range. Maximum will always be the
programmed parameter value.
With a negative Dynamic Amount value, a PEDAL will start at the level set In the
parameter edit mode and decrease the value as h is depressed. Minimum will always
be the programmed parameter value.
To Next Page
Loading...
Need help?
General
